User's Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Detergents and care products
Consumption data
87
Note for test institutes
*
Test programme in accordance with EN 60456 and energy label with
Directive 1061/2010
With the PowerWash washing technique, during the heating phase, the temper-
ature measured by the sensor in the suds container is higher than the actual
temperature of the laundry.
The temperature measured at the sensor does not reflect the temperature of
the laundry.