User's Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Detergents and care products
Settings
93
Maximum rinse level
This function is important for allergy
sufferers as it achieves excellent rinse
results.
The water level in the rinses can be per-
manently set to the highest value. The
water consumption will be increased.
The maximum rinse level is deactivated
as standard.
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Cot-
tonsprogramme with a temperature of
70°C or higher is selected.
Suds cooling must be activated:
– To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin
– In buildings where the drainage pipes
do not comply with DIN1986
Suds cooling is deactivated as stand-
ard.
Low water pressure
If the water pressure is below 100kPa
(1bar), the washing machine cancels
the programme and the Water intake
See fault message appears.
If the on-site water pressure cannot be
increased, activating this function will
prevent the programme from being can-
celled.
Low water pressure is activated as
standard.
Anti-crease
The anti-crease function reduces
creasing after the end of the pro-
gramme.
At the end of the programme, the drum
continues to turn at intervals for up to
30minutes. The washing machine door
can be unlocked at any time by touch-
ing the Start/Add laundrysensor control
and then opened.
Anti-crease is activated as standard.