User's Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- Buzzer volume
- Keypad tone
- Welcome tone
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Detergents and care products
Settings
94
Miele@home
Control the networking of your wash-
ing machine with your WiFi network.
The following points may appear in the
sub-menu:
Set up
This message only appears if the wash-
ing machine has not yet been connec-
ted to a WiFi network.
Please refer to “Before using for the first
time” for instructions on how to set up
the connection.
Deactivate (visible if Miele@home is ac-
tivated)
Miele@home remains set up, the WiFi
function is switched off.
Activate (visible if Miele@home is deac-
tivated)
The WiFi function is reactivated.
Connection status (visible if Miele@home
is activated)
The following values are displayed:
– The quality of WiFi reception
– The network name
– The IP address
Set up again (visible if set up)
Resets the WiFi login (network) to im-
mediately re-establish a new connec-
tion.
Reset (visible if set up)
– The WiFi is switched off.
– The WiFi connection will be reset to
the factory default setting.
The network configuration should be re-
set whenever a washing machine is be-
ing disposed of or sold, or if a used
washing machine is being put into oper-
ation. This is the only way to ensure
that all personal data has been re-
moved and the previous owner will no
longer be able to access the washing
machine.
A new connection setup has to be car-
ried out in order to use the Miele@home
setting again.