Operating instructions/Installation instructions

Installation
*
I
N
S
T
A
L
L
A
T
I
O
N
*
80
Water intake
The washing machine can be
connected to a portable water supply. A
non-return valve is not needed unless
required by building code.
The washing machine has ½“ (13mm)
pressure hoses with ¾” (19mm) female
hose thread connections. If there is no
water hookup, contact a plumber to
install a connection. Make sure that the
sealing ring is seated properly on the
hose connector.
Replace the hose only with a genuine
Miele hose, or with a hose able to
withstand up to 145 psi (10.000kPa)
pressure. The water valve connector
must also be able to withstand 145 psi
(10.000kPa).
The bolted connection is under water
pressure. Open the water supply
slowly to check for leaks. Adjust the
rubber seal and the bolted
connection if necessary.
Maintenance
Only use a genuine Miele hose that has
been tested to withstand pressure of at
least 1,015psi (7,000kPa) should you
ever need a replacement.
 A filter is located in the open end
of the inlet hose and another in the
intake point to protect the inlet valve.
Neither filter may be removed.