User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Settings
106
You can use the settings to alter the
washing machine's electronics to suit
changing requirements.
The settings can be altered at any
time.
Accessing the settings menu
Switch on the washing machine.
Scroll to the second page in the main
menu.
Touch the Settings sensor.
The display will change to show the
Settings menu.
Selecting settings
The settings are grouped into different
areas.
11:02
Controls /
Display
Settings
Network
Programme
sequence
Appliance
parameters
Installation
requirements
Select the required area.
Scroll through the list until the setting
you want appears.
Touch the sensor to select the setting
you require.
Changing a setting
Change the value displayed and con-
firm with OK.
or
Touch an option to select it.
An option which is selected will be
highlighted orange.
The option is saved. The display will
then switch to the Settings menu, or go
back to the previous menu level.
Closing the settings menu
Touch the sensor.
The display will then go back to the pre-
vious menu level.
Touch the sensor.
The display will change to show the
main menu.