User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Settings
110
Maximum rinse level
The water level in the rinses can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent rinse
results. The water consumption will be
increased.
The maximum rinse level is deactivated
as standard.
Soak duration
You can set a duration for the soak
process of between 30minutes and
6hours.
The duration can be selected in
30minute increments. When the Soak
extra option is selected, the laundry will
be soaked for the duration selected.
A duration of 0: 30h is set as standard.
Longer Pre-wash Cottons
If you require a longer pre-wash, you
can extend the standard pre-wash
time of 25minutes in the Cottons pro-
gramme.
- Normal (factory setting)
25minute pre-wash.
- + 6 min
31minute pre-wash.
- + 9 min
34minute pre-wash.
- + 12 min
37minute pre-wash.
Gentle action
With gentle action activated, drum
agitation is reduced. In this way, lightly
soiled items can be washed more
gently.
Gentle action can be activated for the
Cottons and the Minimum iron pro-
grammes.
Gentle action is deactivated as stand-
ard.
Anti-crease
The Anti-crease function reduces
creasing after the end of the pro-
gramme.
At the end of the programme, the drum
continues to turn at intervals for up to
30min. The washing machine door can
be unlocked at any time by touching the
Start/Stop sensor and then opened.
Anti-crease is activated as standard.