User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Operating the washing machine
17
Moving programmes
You can move the programmes around
in the menu to change the sequence in
which they are displayed.
11:02
2:39
3:19
1:59
1:09h
h h
h
Cottons
Delicates
Minimum iron
Programmes
Help
ECO 40-60
Place your finger on the programme
you wish to move until a border is
displayed around it.
To move the programme, swipe your
finger in the required direction.
Remove your finger when the pro-
gramme reaches the new location.
The programme has moved.
Setting numerical values
You can set numerical values in some
menus.
12 00
11 59
10 58
13 01
14 02
Clock display
OK
Enter the numbers by swiping up or
down. Place your finger on the number
that you want to change and move your
finger in the direction you want. Touch
the OKsensor control to accept the set
numerical value.
Tip: Briefly touching the numbers will
bring up the numerical keypad. Once a
valid number has been entered, the
OKsensor control will be highlighted
green.