User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Before using for the first time
22
3. Set clock format
The time of day can be displayed in 12-
hour or 24-hour clock format.
Select the clock format you want and
confirm this with the OKsensor con-
trol.
The display will then bring up the
screen for setting the time of day.
Setting the time
This message only appears if the
washing machine has not yet been
connected to a WiFi network.
The time of day is set automatically
when a connection is established with
a WiFi network.
12 00
11 59
10 58
13 01
14 02
Clock display
OK
Place your finger on the number that
you want to change and move your
finger in the direction you want.
Confirm with the OKsensor control.
4. Remove the transit bars
Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing ma-
chine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in “Installation and connection”.
Touch the OKsensor control to con-
firm that the transit bars have been
removed.
The following message will then appear
in the display:
Remove transit bars and observe “Warn-
ing and Safety instructions” and “Before us-
ing for the first time” in the operating instruc-
tions.
Confirm the message with the
OKsensor control.
The display will then change to the
screen for setting up TwinDos.