User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Before using for the first time
23
5. Commissioning TwinDos
Skip Continue
Set up “TwinDos”?
Touch the Continuesensor control to
set TwinDos up straight away.
Tip: To postpone setup until later:
Touch the Skipsensor control. The fol-
lowing message will then appear in the
display:
It is possible to set up later in “Settings” /
“TwinDos”.
Confirm with the OKsensor control.
Settings for compartment
The procedure for Miele UltraPhase 1
and Miele UltraPhase 2 is described be-
low. The procedure for other detergents
is similar.
No agent
Agent for comp.
Miele
UltraPhase 1
Universal
detergent
Colour
detergent
Delicates
detergent
Delicates/
Woollens
OK
11:02
Touch the Miele UltraPhase 1sensor
control.
The following message will then appear
in the display:
Please enter the dosing recommendation
of your detergent for a wash with normal
soiling. Take note of your water hardness
level.
The dispensing quantity for
UltraPhase1 is preset for (hard-
ness level II).
58
57
56
59
60
Dosage for comp.
ml
OK
11:02
Confirm the preset value with the
OKsensor control, or change the
value.
UltraPhase1
Hardness level I 46ml
Hardness level II 58ml
Hardness level III 70ml
The following appears in the display:
Insert container