User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Before using for the first time
25
Settings for compartment
The dispensing quantity for
UltraPhase2 is preset for (hard-
ness level II).
45
44
43
46
47
Dosage for comp.
ml
11:02
OK
Confirm the preset value with the
OKsensor control, or change the
value.
UltraPhase2
Hardness level I 36ml
Hardness level II 45ml
Hardness level III 54ml
The following appears in the display:
Insert container
Remove the foil from the detergent
cartridge.
Push the UltraPhase2 detergent
cartridge into compartment2 until it
locks into position.
When the cartridge is pushed in, the
display message switches to:
“TwinDos” is set up. Changes can be
made in “Settings” / “TwinDos”.
Confirm with the OK sensor.
Close the TwinDos access panel.
The display will then change to the
screen for the calibration programme.