User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Washing environmentally and economically
28
Feedback
You can view information about the en-
ergy and water consumption of your
washing machine with the pull-down
menu.
The following information will appear in
the display:
- An estimate of the energy and water
consumption before the programme
begins.
- The actual energy and water con-
sumption during the programme or at
the end of the programme.
11:02
40 °C 1600
1:57
Cottons
h
Overview
Temperature Spin speed
TwinDos Extras
not selectednot selected
Timer Save
rpm
Open the pull-down menu.
1. Estimate
The estimated energy and water con-
sumption levels will be displayed as a
bar chart on the right-hand side.
The more bars visible, the higher the
energy or water consumption.
The estimate will vary depending on the
wash programme, temperature and any
Extras selected.
2. Actual consumption
You can view the actual amount of en-
ergy and water used by a programme
both during and at the end of the pro-
gramme.
The costs can also be displayed. See
“Settings - Consumption” for more de-
tailed information on costs.
The consumption will alter as the pro-
gramme progresses.
If the door is opened or the machine
has switched off automatically at the
end of the programme, the data will
revert to the estimated consumption.
Tip: You can view the consumption
data for the last wash programme and
for total consumption (see “Settings,
Consumption”).