User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
3. Select programme settings
31
Selecting a temperature
You can alter the preset temperature
of a wash programme.
The temperatures reached inside the
washing machine might not be the
same as the temperatures selected.
Perfect wash results are achieved
through a combination of energy use
and wash duration.
Touch the Temperaturesensor.
Select the desired temperature.
The display will change to the Over-
viewmenu.
Selecting a spin speed
You can alter the preset spin speed of
a wash programme.
Touch the Spin speed sensor.
Select the spin speed you want.
The display will then change to show
the Overview menu.
Activating TwinDos
TwinDos dispensing is automatically
activated for all programmes in which
dispensing is possible.
1. Switch TwinDos on or off
Touch the TwinDos sensor and select
Off or On.
2. Select the detergent
When using Miele's 2-phase system
you must set the colour of the laundry.
Select Whites for loads of white items,
or Colours for loads containing col-
oured items.
If using a different type of detergent,
this must be selected.
Select compartment or .
Tip: Only those detergents that can be
used with the programme are dis-
played.
3. Selecting the degree of soiling
The display will ask you to enter the de-
gree of soiling of the laundry.
Select Light, Normal or Heavy.
Confirm your selection with the
OKsensor control.
Automatic dispensing is now switched
on.
The display will change to the Over-
viewmenu.
See “5.Adding detergent – TwinDos”
for more information.