User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
6.Starting the programme
40
Starting the programme
The programme can be started when
the Start/Stopsensor control is flashing
on and off.
Touch the Start/Stopsensor control.
The door will lock and the programme
will start.
The programme status will appear in
the display.
11:02
Cottons
Status
Time left
h2:27
Main wash
Add laundry
The washing machine will keep you up-
dated on the programme status and the
time remaining for the programme to
run.
If a delay start period has been selec-
ted, this will count down in the display
until the programme starts.
The drum lighting switches off once the
programme has started.
Energy savings
After 10minutes, the indicators dim.
The Start/Stop sensor flashes slowly.
To reactivate the indicators:
Touch the Start/Stop sensor (this
does not have any effect on a pro-
gramme that is running).
Adding laundry during a pro-
gramme sequence (AddLoad)
Laundry can be added or removed at
any time.
Touch the Add laundrysensor con-
trol.
The following appears in the display:
Please wait
The programme will stop and the door
will unlock.
The following appears in the display:
11:02
Cottons
Status
Add laundry
The door can be opened.
Open the door and add or remove
laundry.
Close the door.
Touch the Start/Stopsensor control.
The programme will continue.
Laundry cannot usually be added or re-
moved if:
- The suds temperature is above 55°C
- The water inside the drum is above a
certain level