User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Programme sequence
57
= low water level
= medium water level
= high water level
= intensive rhythm
= normal rhythm
= sensitive rhythm
= ultra sensitive rhythm
= handwash rhythm
= carried out
– = not carried out
This washing machine has fully elec-
tronic controls with automatic load con-
trol. The washing machine takes in the
right amount of water required for the
programme depending on the amount
of laundry and its absorbency rate.
The programme sequences outlined in
the chart are based on the basic pro-
gramme with a full load.
The washing machine programme se-
quence display shows which stage of
the programme has been reached.
Special features in the pro-
gramme sequence
Anti-crease:
At the end of the programme the drum
continues to turn at intervals for up to
30minutes to help prevent creasing.
Exception: There is no anti-crease
phase in the Woollens and Silks
programmes.
The door can be opened at any time
during the anti-crease phase.
1)
If a temperature of 60°C or higher is
selected, two rinses are carried out. If
a temperature of less than 60°C is
selected, three rinses are carried out.
2
An additional rinse is carried out if:
- there is too much foam in the drum
- a spin speed lower than 700rpm has
been selected.
3)
An additional rinse is carried out if:
- The Extra rinse Extra has been selec-
ted
4
Run-up to spin: A run-up to spin is
carried out before the wash process
begins to deflate down-filled items.
Subsequent water intake for the main
wash is through compartment .