User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Timer
63
The Timer can be used to set the time
you wish a programme to finish or start
at. The programme start can be delayed
by up to 24 hours.
Setting the timer
Touch the Timer sensor.
Select the Finish at or Start at option.
Set the hours and the minutes with
the OK sensor.
Changing the timer
The selected times for the timer can be
changed before the programme starts.
Touch the or sensor.
Change the specified time and con-
firm with the OK sensor.
Deleting the timer
The selected time for the timer can be
changed before the programme starts.
Touch the or sensor.
The selected time for the timer appears
in the display.
Touch the Delete sensor.
Confirm with the OK sensor.
The selected time for the timer is now
deleted.
To start the timer
Touch the Start/Stop sensor.
The door will lock and the time until the
programme starts will appear in the dis-
play.
After the programme has started, the
selected time can only be changed or
cancelled by interrupting the pro-
gramme.
The programme can now be started.
Touch the Start immediately sensor.