User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Problem solving guide
83
The door will not open
Problem Cause and remedy
The door cannot be
pulled open during a
programme.
The door is locked during a programme.
Touch the Start/Stop sensor to cancel the pro-
gramme.
The programme is cancelled, the door will unlock and
you will be able to pull it open.
There is still water in the drum and the machine is un-
able to drain.
Clean the drain filters and the drain pump as de-
scribed in “Opening the door in the event of a
blocked drain outlet and/or power failure”.
Comfort cooling
appears in the display
after a programme has
been cancelled.
To protect the user against scalding, the door cannot
be opened if the suds temperature is higher than
55°C.
Wait until the temperature in the drum has de-
creased and the message has gone out in the dis-
play.
The door will not open
after the Steam care or
Freshen upprogramme
has finished.
The Steam care or Freshen upprogramme has been
started multiple times in succession. Steam applica-
tion has caused the temperature inside the drum to
rise above 55°C. The door is locked to protect
against scalding.
Wait a few minutes for the temperature inside the
drum to drop.
The following appears
in the display:
The door lock is jammed.
Call Service.
The door lock has jammed.
Call Service.