User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Installation
*INSTALLATION*
93
Levelling the machine
The washing machine must stand per-
fectly level on all four feet to ensure
safe and proper operation.
Incorrect installation may increase elec-
tricity and water consumption and may
cause the machine to move about.
Screwing out and adjusting the feet
The four adjustable screw feet are used
for levelling the washing machine. The
machine is supplied with all four feet
are screwed in.
Using the spanner supplied, turn
counter nut 2 in a clockwise direction.
Then turn counter nut 2 together with
foot 1 to unscrew.
Use a level to check that the washing
machine is standing level.
Hold foot 1 securely with a pipe
wrench. Turn counter nut 2 again us-
ing the spanner supplied until it sits
firmly up against the housing.
Risk of damage due to incor-
rectly aligned washing machine.
There is a danger of the washing ma-
chine moving about if the feet are not
secured.
Turn all four counter nuts for the feet
until they sit firmly up against the
housing. Please also check this for
the feet which did not need adjust-
ment.