User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Installation
*INSTALLATION*
98
Maintenance
Only use a Miele Waterproof system
hose should you need a replacement.
Damage caused by dirty water.
This washing machine has a filter in
the hose connection to the casing to
protect the solenoid valve.
This filter must not be removed.
Hose extension
A 1.5 metre long (metal) extension hose
is available from your Miele dealer or
the Miele Spare Parts Department as an
optional extra.
This hose is tested to withstand pres-
sures of up to 14,000 kPa and can be
used as a flexible extension to the water
supply.
Operation with cold water and
alternative water supply
In addition to cold water, the washing
machine can be used with an alternat-
ive water supply.
Alternative water supplies:
- Hot water
- Soft water
- Rain water
- Well water
Damage caused by incorrect wa-
ter connection.
For hygiene and technical reasons,
the washing machine must always
be connected to cold mains water.
Always connect the washing ma-
chine to cold mains water.
Tip: See “Settings – Water intake” for
instructions on how to programme the
water supply.
Markings on the water intake hoses
Cold water (cold
mains water)
= Silver label
Hot water or al-
ternative water
supply
= Red label