User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Garment care label symbols
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the transit bars
- Fitting the transit bars
- Levelling the machine
- The water protection system
- Connection to the water supply
- Operation with cold water and alternative water supply
- Water drainage
- Electrical connection
- Consumption data
- Technical data
- Settings
- Detergents and care products
Installation
*INSTALLATION*
99
Cold water (default setting)
The washing machine will be operated
with cold mains water only.
The other intake hose is secured to the
back of the washing machine.
Hot water
- The preferred temperature is 55°C.
The temperature must not not exceed
60°C. Consult a qualified plumber if
the temperature exceeds 60°C.
- You can heat up your water with
cheaper, primary energy sources, e.g.
gas, solar power, oil.
- Before connecting to the mains water
stopcock, check that the outflow of
cold water does not exceed 5litres.
Each additional litre of cold water re-
duces the energy efficiency.
- If the hot water tap is turned off for
some time, the washing machine will
automatically switch to the cold wa-
ter connection. This safety measure
is not intended for the permanent op-
eration of the appliance and will af-
fect wash results.
Soft water, rain water and well water
1. For hygiene reasons water should be
at least of the quality used for
bathing in.
2. The chemical composition of the wa-
ter must not endanger parts of the
machine.
3. The water must not contain any solid
particles e.g. sand. We recommend
an upstream filter with a filtration
throughflow of 0.1mm.
Other specifications for water quality
Iron ≤ 0.10mg/l
Manganese ≤ 0.05mg/l
Copper ≤ 0.10mg/l
Zinc ≤ 1.50mg/l
Chlorides ≤ 200.00mg/l
pH value 5-9.5
Water hardness ≥ 5°d
Water temperat-
ure
≤ 60°C
The operator is responsible for en-
suring a suitable water quality.