Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Add detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Delay start/SmartStart
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- The program is canceled and a fault indicator light lights up on the control field
- During the program sequence, a symbol appears on the time display
- At the end of the program, an indicator light lights up on the control field
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- Buzzer
- Keypad tone
- PIN code
- switch-off status
- Memory
- Water intake
- Gentle action
- Reducing the temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Chlorine bleach
- Display brightness dimmed
- Welcome tone
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Detergents and care products
Before using for the first time
17
3. Starting the calibration
program
For optimum water and energy
consumption and excellent wash
results, it is important to calibrate the
washing machine.
To do this, the Normal program must
be run without laundry and without
detergent.
Turn on the faucet.
Turn the program selector to the
Normalposition.
The washing machine is now switched
on and the temperature Warm+ and
spin speed Max light up.
Touch the Start/Add laundrysensor
button.
The wash program will start.
After 15minutes, the indicators dim.
Opening the door at the end of the
program
The door remains locked during the
Anti-crease phase. The control field
lights up for the first 10minutes. The
control field then goes out and
theStart/Add laundry sensor button
flashes.
Turn the program selector to the
position.
appears on the time display and the
indicator light goes out.
The door will be unlocked.
Tip: After the Anti-crease phase, the
washing machine will have switched off
and the door unlocked automatically.
The control field is completely dark.
Take hold of the door and pull it
open.
Tip: Leave the door slightly open to
allow the drum to dry.
The appliance is now ready for use.