Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Add detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Delay start/SmartStart
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- The program is canceled and a fault indicator light lights up on the control field
- During the program sequence, a symbol appears on the time display
- At the end of the program, an indicator light lights up on the control field
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- Buzzer
- Keypad tone
- PIN code
- switch-off status
- Memory
- Water intake
- Gentle action
- Reducing the temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Chlorine bleach
- Display brightness dimmed
- Welcome tone
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Detergents and care products
Frequently Asked Questions
The program is canceled and a fault indicator light lights up on
the control field
Problem Possible cause and solution
The fault indicator light
lights up, and ap-
pear alternately on the
time display, and the
buzzer sounds.
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the filter and the pump.
The maximum drain height is 39⅜" (1m).
The fault indicator light
lights up, and ap-
pear alternately on the
time display, and the
buzzer sounds.
The water intake is blocked or restricted.
Check whether the water supply is turned on
properly.
Check whether the intake hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water intake is blocked.
Clean the filter.
The fault indicator light
lights up, and
appear alternately on
the time display, and
the buzzer sounds.
The water protection system has reacted.
Close the water supply.
Contact Service.
and alternate on
the time display and the
buzzer sounds.
There is a fault.
Disconnect the washing machine from the power
supply. Unplug the appliance or switch off the
breaker.
Wait at least 2minutes before reconnecting the
washing machine to the power supply.
Then switch the washing machine on again.
Restart the program.
If the fault message appears again, contact Miele
Customer Service.
48