Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Add detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Delay start/SmartStart
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- The program is canceled and a fault indicator light lights up on the control field
- During the program sequence, a symbol appears on the time display
- At the end of the program, an indicator light lights up on the control field
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- Buzzer
- Keypad tone
- PIN code
- switch-off status
- Memory
- Water intake
- Gentle action
- Reducing the temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Chlorine bleach
- Display brightness dimmed
- Welcome tone
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Detergents and care products
Frequently Asked Questions
General problems with the washing machine
Problem Possible cause and solution
Large amounts of deter-
gent residue remain in
the detergent dispens-
ing drawer.
The water pressure is too low.
Clean the filter in the water intake.
Please note that the water pressure must be at
least 14.5psi (100kPa).
Powder detergent used in conjunction with water
softeners tends to become sticky.
Clean the detergent dispenser drawer and in
future, add detergent first and then the water
softener.
The fabric softener is
not completely dis-
pensed or too much
water remains in the
compartment.
The siphon tube is either positioned incorrectly or
clogged.
Clean the siphon tube, see “Cleaning and care -
Cleaning the detergent drawer”.
At the end of the pro-
gram there is still liquid
in the capsule.
The small pipe in the detergent dispenser drawer
onto which the capsule is placed is blocked.
Clean the small pipe.
Not a fault.
For technical reasons, a small amount of water will
remain in the capsule.
There is water next to
the capsule in the fabric
softener compartment
The sensor button was not activated.
Make sure that you remember to activate the
sensor button the next time you insert a
capsule.
An empty capsule was not removed at the end of the
last wash program.
Remove and then dispose of the empty capsule at
the end of each wash cycle.
The small pipe in the detergent dispenser drawer
onto which the capsule is placed is blocked.
Clean the small pipe.
52