Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Add detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Delay start/SmartStart
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- The program is canceled and a fault indicator light lights up on the control field
- During the program sequence, a symbol appears on the time display
- At the end of the program, an indicator light lights up on the control field
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- Buzzer
- Keypad tone
- PIN code
- switch-off status
- Memory
- Water intake
- Gentle action
- Reducing the temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Chlorine bleach
- Display brightness dimmed
- Welcome tone
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Detergents and care products
Programmable functions
78
Reducing the temperature
At high altitudes, water has a lower
boiling point. Miele recommends
switching on the reduce temperature
setting at altitudes of 6,560ft
(2,000m) or above to prevent water
from boiling. The maximum
temperature is reduced to 176°F
(80°C), even if a higher temperature
has been selected.
Options
= The reduce temperature setting
is switched off (factory
setting)
= The reduce temperature setting
is switched on
Maximum rinse level
The water level in the rinse can be
permanently set to the highest value.
This function is important for allergy
sufferers as it achieves excellent wash
results. The water consumption will be
increased.
Options
= Maximum rinse level is
switched off (factory setting)
= Maximum rinse level is
switched on
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a
Normal program with a temperature of
158°F (70°C) or higher is selected.
Suds cooling should be activated:
- To prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- Where the drainage pipes do not
comply with DIN 1986.
Options
= Suds cooling is switched off
(factory setting)
= Suds cooling is switched on
Anti-crease
The Anti-crease function helps prevent
creasing after the end of the program.
At the end of the program, the drum
continues to turn for up to 30minutes.
The door can be opened at any time
during the Anti-crease phase.
Options
= The Anti-crease function is
switched off
= The Anti-crease function is
switched on (factory setting)