Instructions / Assembly

1
Questions?/ Des questions?/ ¿Preguntas? 1-800-334-6871 [e-mail]
Instruction Manual / Manuel d’instructions/ Instrucciones
OPERATING YOUR WORKLIGHT
1. Make sure your worklight is fully charged.
2. Push the switch once to turn both panels on.
3. Push the switch again to turn one panel on.
4. Push the switch a third time to turn the worklight off.
REcHARGING WORKLIGHT
1. Turn off worklight.
2. Plug the supplied cable into the worklight and any USB 2.0 or 3.0 Port. Maximum ratings:
5 Vdc, 1.0A.
NOTE: LED indicator light glows red while the batteries are charging. When the light is fully
charged, the LED indicator light turns to green. Battery operating time: 3 hours on a
full charge.
HANGING WORKLIGHT
•Triangular spacer on 2 light panels can be used for hanging.
•Hanging hook can rotate 360°.
•Powerful rare earth magnets are contained in each panel. Clings to most metal surfaces.
•Folding D-ring rotates 90° for attachment.
WARNING: Do not use magnet for horizontal overhead mounting.
CAUTION: Do not slide on finished painted surfaces as magnet may scratch finish.
MAINTENANcE
NOTE: Before performing any maintenance, ALWAYS unplug worklight.
•Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth and a mild soap,
if needed. Be sure not to get the electrical plug wet.
•NEVER submerge any part of the worklight in any solution to clean it.
•DO NOT USE solvents such as gasoline, turpentine, etc. to clean unit.
•Aerosols and other chemicals may fog the clear polycarbonate lens.
1-YEAR LIMITED WARRANTY
THE FOLLOWING WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES,
WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING, BUT NOT LIMITED TO, ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
Eaton’s Cooper Lighting Business (“Eaton’s Cooper Lighting”) warrants to customers that, for
a period of one year from the date of purchase, Eaton’s Cooper Lighting Business (“Eaton’s
Cooper Lighting”) products will be free from defects in materials and workmanship. The
obligation of Eaton’s Cooper Lighting Business (“Eaton’s Cooper Lighting”) under this warranty
is expressly limited to the provision of replacement products. This warranty is extended only
to the original purchaser of the product. A purchaser’s receipt or other proof of date of original
purchase acceptable to Eaton’s Cooper Lighting Business (“Eaton’s Cooper Lighting”). This
is required before warranty performance shall be rendered. This warranty does not apply to
Eaton’s Cooper Lighting Business (“Eaton’s Cooper Lighting”) products that have been altered
or repaired that have been subjected to neglect, abuse, misuse or accident (including shipping
damages). This warranty does not apply to products not manufactured by Eaton’s Cooper
Lighting Business (“Eaton’s Cooper Lighting”) which have been supplied, installed,
PAcKAGING cONTENTS/cONTENIDO DEL PAQUETE/cONTENU DE L’EMBALLAGE
WARNINGS AND cAUTIONS
IMPORTANT SAFETY INSTRUCTIONS
DANGER - TO REDUCE THE RISK OF ELECTRIC FIRE OR ELECTRIC SHOCK, CAREFULLY
FOLLOW THESE INSTRUCTIONS.
WARNING - When using electrical fixtures, basic precautions should always be
followed, including the following:
•Readtheseinstructions.
•Keeptheseinstructions.
•DO NOT handle this worklight or try to plug it in when your hands are wet or damp or when
you are standing on a wet or damp surface or in water.
•To reduce the risk of injury, close supervision is necessary when a worklight is used
near children.
•ONLY USE attachments recommended or included by the manufacturer.
•ONLY USE the charger specified by the manufacturer to recharge.
•DO NOT use in potentially dangerous locations, such as flammable or
explosive atmospheres.
•To reduce the risk of electric shock, do not put in water or other liquid. Do not place or
store worklight where it can fall or be pulled into a tub or sink. NEVER ATTEMPT TO
PICK UP PLUGGED-IN WORKLIGHTS WHEN THEY FALL INTO WATER BECAUSE FATAL
ELECTROCUTION COULD RESULT.
•This fixture MUST ALWAYS BE USED in accordance with all electrical and safety codes
and ordinances, including the most recent National Electric Code (NEC) and with the
Occupational Safety and Health Ace (OSHA) Volume 1 on General Industry Standards
and interpretations.
•Lithium-Ion batteries must be disposed of in accordance with local waste ordinances
and regulations.
•DO NOT replace batteries.
•DO NOT dispose of batteries in a fire.
•DO NOT short the positive-negative terminals together.
•DO NOT puncture this battery pack. DO NOT work on this battery pack.
•DO NOT disassemble worklight. The worklight does not have any user serviceable parts.
•This product must not be disposed of together with domestic waste. This product has to be
disposed at an authorized place for recycling of electrical and electronic appliances.
•This product is not intended to be repaired by service personnel in case of failure or
component defect.
•This product must be disposed of properly according to local regulations.
•NEVER operate the light with the clear protective lens removed.
•KEEP AWAY from excessive heat or flame.
•DO NOT look directly into the light.
SAVE THESE INSTRUCTIONS.
LED140
LED140C
A. Might-D-Light
™
ENGLISH
B. USB to Micro USB Cable
USB con cable Micro USB
Câble USB à micro USB