Installation Guide

18
rev 07.12.12
At this stage of the installation, the opener should be installed on
the gate and the closed position stop plate should be in place.
Check List
•Thegateisplumb,level,andswingssmoothlyonitshinges.
•Aplateorsupportwasaddedforthegatebracket(ifnecessary).
•Theopenerislevelandmountedonthecenterlineofthegate.
•Allhardwareistightenedatthistime.
Gate Swings Evenly and Freely
Hung Firmly and Plumb
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
Horizontal Cross Member
Single Gate Opener
Post Bracket Assembly
Gate Bracket
Closed Position Stop Plate
Preparing to Activate the System
In order to have easy access to the control board during the rest of the
installation, remove the opener and remount it upside down.
Bottom
Access Panel
ON
OFF
ON/OFF
Switch
IMPORTANT:
Return the opener arm to the
upright position when installation is
complete to prevent water damage
to the control board.