Installation Guide

28
rev 07.12.12
Input Connections
 •Allcontrolinputsaredry-contact,normallyopen,inputs.DONOTapplyexternalvoltagesources
to these inputs.
 •AllinputsareconnectedwithrespecttoCOMMONterminal.
 •ThestatusLEDwillblinkoncewhenanyinputisactivated.
1 COMMON: Circuit common (reference
for all logic input)
2 CYCLE: (Typically for use with push
button or hard-wired keypad)
 •Eachactivationatthisinputwillcycle
the operation as follows:
OPEN–STOP–CLOSE–STOP–OPEN
3 EDGE: (Typically for use with safety
edge device)
 •Activationofthisinputwhilethe
gate is closing will cause the gate
to stop and reverse direction for
approximately 2 seconds.
 •Activationofthisinputwhilethegate
is opening has no effect (gate will
continue to open).
 •Activationofthisinputwhilegateis
idle will prevent gate from closing.
4 SAFETY: (Typically for use with photo
beam device, loop detector or other
non-contact sensors)
 •Activationofthisinputwhilethegate
is closing will cause the gate to stop
and return to the opened position.
 •Activationofthisinputwhilethegate
is opening has no effect (gate will
continue to open).
 •Activationofthisinputwhilegateis
idle will prevent gate from closing.
5 EXIT: (Typically for use with exit loop or wand)
 •Activationofthisinputwillopenthegateifit’snotalreadyattheopenposition
 •Activationofthisinputwhileatopenlimitwillrestarttheautoclosetime(ifenabled).
6/7 AUX/OUT: Multi-function output: refer to DIP Switch 4 on page 23.
CHARGING POWER
RCVR
GRN
BLK
RED
EXIT
SAFETY
EDGE
CYCLE
COMMON
LINK
AUX
OUT
SOLAR
INPUT
18VAC/
H L
1
2
3
4
5
7
6
CONNECTING ACCESSORIES