Installation Guide

Maintenance & Troubleshooting
33
•Onallgatesweighing250lb.ormore,routinely
grease the ball bearing hinges at least 4 times a year;
more frequently if the gates are near a coastal area.
•Keepingafewmothballsinthecontrolboxwill
discourage insects from entering it and damaging the
control board.
•Cleanthepush-pulltubewithasoft,dryclothand
apply silicone spray to it at least once per month.
•Whileoxidationisanormalpartofweathering
of equipment that is exposed to the elements, we
recommend you apply silicone spray to the front and
rear mounts to minimize this effect.
Maintenance Tips
POWER
INPUTS
LOCK
PWR
AUX
R LY
CONTROL
OUTPUTS
GTO 18VOLT
TRANSFORMER
OR SOLAR
Wire from
Automatic
GTO Lock
GTO LOCK
Connecting GTO Automatic Lock
Connecting Additional Devices
GTO Lock Connection:
Connect the red and black leads from the lock to the GTO LOCK
terminal on the GTO/PRO® 2000XL control board.
GTO Lock:
For use exclusively with GTO Lock (FM143 or FM144).
Connecting other devices to these terminals may cause incorrect
operation and void your warranty. You do not use the lock board
with this control board.
•These2terminalsarenormallyopen'dry-contact'(novoltage)relayouput.
•These2terminalsareON(shorted)wheneverthegateismovingandOFF(opened)otherwise.
•These2terminalsmaximumratingis24Vdc,1Amp.
Connecting Other Auxiliary Devices (Mag Locks, Sirens, Lights. . .}