Product Manual B

12 MM-LPS13 Installation Manual
rev 05.16.13
Step 4
Strip the ends of the low voltage wire and attach ends to
the transformer terminals.
To prevent damage to transformer, make sure the
exposed wire ends do not touch each other!
Step 5
Plug the transformer into a weatherproof electrical outlet.
NOTE: Use of a surge protector is strongly recommended.
Connecting Solar Panel(s) (Only if transformer is not used)
NOTE: NEVER USE THE SOLAR PANEL AND THE AC
TRANSFORMER AT THE SAME TIME! It will damage
the control board.
Feed the solar panel wires into the control box and
attach them to the appropriate terminals on the
control board (see illustration). The RED solar panel
wire goes to the (+) POSITIVE solar terminal and the
BLACK solar panel wire goes to the (–) NEGATIVE
solar terminal.
Tighten set screws against exposed end of wires.
SURGE PROTECTOR
Transformer
RED
BLK
ORG
BLU
GRN
CLS EDG
OPN EDG
RED
GRN
ORG
BLU
WHT
BLK
ORG
BLU
GRN
CLS EDG
OPN EDG
LEARN
AUTOCLOSE
INERTIA
STATUS
PULL/PUSH
SNGL/DUAL
SEQ1
SEQ2
MIN
MAX
MIN
MAX
OFF
60
120
BATT
+
–
OBSTRUCT
SENS.
RCVR
R
B
G
ALARM
SECOND OPERATOR
FIRST OPERATOR
POWER IN
18VAC SOLAR
~ ~ – +
ACCESSORY
PWR. SW.
Red
Black
(–)
(+)
Red
Green
Black
RED
BLK
ORG
BLU
GRN
CLS EDG
OPN EDG
RED
GRN
ORG
BLU
WHT
BLK
ORG
BLU
GRN
CLS EDG
OPN EDG
LEARN
AUTOCLOSE
INERTIA
STATUS
PULL/PUSH
SNGL/DUAL
SEQ1
SEQ2
MIN
MAX
MIN
MAX
OFF
60
120
BATT
+
–
OBSTRUCT
SENS.
RCVR
R
B
G
ALARM
SECOND OPERATOR
FIRST OPERATOR
POWER IN
18VAC SOLAR
~ ~ – +
ACCESSORY
PWR. SW.
Red
Black
(–)
(+)
Red
Green
Black
Step 6
Connecting The Receiver
Temporarily run the receiver to the outside of the
fence, clear of the moving path of the gate at this time
(Permanent mounting instructions on page 17).
Feed the receiver wires into the control box and attach
them to the appropriate terminals on the control board
(see Illustration ).
Tighten set screws against exposed end of wires.
Receiver wire
DIP SWITCH CONTROL BOARD SETTINGS
1234
ON
OBSTRUCT
SENS.
PULL/PUSH
SEQ1
SNGL/DUAL
SEQ2
LEARN
DIP switches
MIN MAX
BEFORE Changing the DIP Switch, make sure that the
control box power switch is OFF.
The DIP Switches determine the opening direction of the gate
opener (either right to left, or left to right).
If your gate opens from Right to Left (from the operator side of the
gate). DIP Switch 4 is set to “Pull.”
If your gate opens from Left to Right (from the operator side of the
gate), you will need to adjust DIP Switch 4 to “Push.”