Product Manual B
16 MM-LPS13 Installation Manual
rev 05.16.13
Program Your Personal Transmitter Setting
All transmitters are set to a standard code at the factory and
are ready to operate your Mighty Mule gate operator. For
your safety and security, we strongly recommend that you
replace the factory setting with your own personal setting.
Follow the directions below:
NOTE:Ifyouhavemultipletransmitters,youshouldadjustall
of them at this time.
Step 1
Use a small phillips head screw driver to remove the
transmitter cover.
Step 2
Set the transmitter DIP switches using a small screwdriver.
There are nine (9) switches; each can be placed in three
dierentpositions(+,0,–).DO NOT set all the switches in
thesameposition,suchasall+,all0,orall–.OncetheDIP
switches have been reset, replace and close the access cover.
WARNING:Nootheradjustmentsshouldbemadeinsidethe
transmitter.
Step 3
A. Make sure the control box power switch is OFF.
B. Unscrew and remove the control box cover.
C. Press and hold the LEARN button on the control board,
and turn the power switch ON. Release LEARN button.
Wait 15 seconds for the receiver to charge.
D. Press and hold transmitter button until the red STATUS
LEDcomesON.
E. Releasetransmitterbutton.Thenewswitchsettingis
stored in the control board memory.
F. Replace the cover.
Step 4
AT THIS POINT YOU SHOULD TEST RECEIVER RANGE
BEFORE PERMANENTLY INSTALLING IT.
24/7 Troubleshooting Wizard:
http://support.gtoinc.com
The Troubleshooting Wizard has
detailed information about this and
other Installations.
+
0
ECE
1 2 3 4 5 6 7 8 9
1 2 3 4 5 6 7 8 9
ECE
A23S 12V
ALKALINE BATTERY
+
0
–
LED
1234
ON
RCVR
SEQ1
SEQ2
LEARN
STATUS
R B G
AUTOCLOSE
INERTIA
OBSTRUCT
SENS.
PULL/PUSH
SNGL/DUAL
MIN MAX
MIN
OFF 120
60
MAX
STATUS LED
LEARN
BUTTON
PROGRAMMING YOUR PERSONAL TRANSMITTER