Instructions / Assembly

Hang operator with two

5/16”-18 x 1” bolts and nuts

DOOR

RAIL

2”

Attach opener to hanging brackets using two

5/16”-18 x 1” hex bolts and two 5/16”-18 keps

nuts (supplied).

Open and close the door manually. The door

should clear the rail by at least 2”.

Joist under

sheet rock.

Diagonal supoport

for added stability.

Diagonal supoport

for added stability.

IMPORTANT: On a  nished ceiling, be sure there

is a joist to fasten to under the sheet rock where

the cross piece will be located (use a stud  nder).

If there is none, install a 2”x4” cross piece of wood

between the two closest joists to fasten the head

bracket hardware to.

For un nished ceilings: Hold each angle iron in

place, mark and drill 3/16” pilot holes, then attach

with two 5/16” x 1-1/2” lag screws (supplied).

For  nished ceilings use an angle iron cross piece,

secured into ceiling joist with 5/16” x 1-1/2” lag

screws. Attach the two hanging brackets to the

cross piece with two 5/16”-18x1” hex bolts and

5/16”-18 nuts.

For additional stability add a diagonal support

piece of angle iron and secure with 5/16”-18x1”

hex bolts and 5/16”-18 nuts.

NOTE: Installation requirements vary with garage

construction. Hanging brackets should be angled

to provide rigid support. Not all hanging material is

provided.

4 5

5/16”x 1-1/2” Lag Screw 5/16”-18 x 1" Bolt 5/16”-18 Keps Nut

HARDWARE SUPPLIED

Angle Iron