Instructions / Assembly

INSTALLING PHOTO BEAMS

Locate the photo beam brackets

so the beam centerline is 4”-6“ above the oor

Adjust the units so

lenses point toward

each other

Spring clip latches

into detent marks

to hole unit’s position

NOTE: The photo beams infrared light must not be obstructed by the door, or by any part of the door

hardware. Use wooden spacers between the beam brackets and wall if necessary to create proper clearance.

Assemble two photo beam brackets from the

four L-shaped brackets using one 1/4”-20 x 1/2”

bolt and 1/4”-20 keps nut per bracket (supplied).

Use the index marks on the brackets to make the

bracket assemblies equal lengths.

Position the assembled brackets on each side

of the door so the center line of the photo beam

lenses will be between 4”-6”” above the  oor. Drill

5/32” pilot holes and mount the brackets with two

1/4” x 1-1/4” lag screws (supplied).

Insert the photo beams into the bracket holes

from inside the bracket with the lenses of the units

facing each other. Twist the units until the spring

clips lock into a detent mark on the brackets.

Adjust the photo beams so lenses point toward

each other. The spring clip latches into the detent

marks to hold unit’s position.

• Photo beams MUST be installed on the garage door to prevent serious injury or death.

• This required safety reversing sensor MUST NOT be disabled at any time.

• Install the photo beams no higher than 6” above the  oor.

1 2

3 4

WARNING

HARDWARE SUPPLIED

1/4”-20 x 1/2" Bolt1/4” x 1-1/4" Lag Screw 1/4”-20 Keps Nut

Insulated Staples