Instructions / Assembly

22
PROGRAMMING OPENER AND CONTROLS
PROGRAMMING TRAVEL LIMITS
Adjusting the Open and Close Limits
The limit settings control how far the door will open and close. Set the limits so the door opens just short of
any door stops, and closes at the  oor level. Use the wall station or a transmitter to test operate the door. If
required, use the following steps to adjust the limits.
NOTE: If the door does not open or gives an error, adjust the force factor as shown on page 25.
Green LED ashes twice
SETTING THE CLOSED LIMIT
Press the DOWN
and LEARN
buttons for
3 seconds
Lights
ash twice
UP
DOWN
LEARN
COM
BEAM
Green LED ashes twice
SETTING THE OPEN LIMIT
Press the UP
and LEARN
buttons for
3 seconds
Lights
ash twice
SETTING THE DOOR FORCE
RUN THE OPERATOR SIX
COMPLETE UP & DOWN CYCLES
THE OPERATOR AUTOMATICALLY
SETS THE CORRECT DOOR FORCE
6
SETTING THE CLOSE LIMIT
2 RED FLASHES = SET DOWN LIMIT
PRESS UP (+) OR DOWN (-)
TO JOG THE DOOR TO THE
CORRECT POSITION
PRESS LEARN & DOWN
FOR 3 SECONDS
PRESS LEARN TO STORE LIMIT
LEARN
DOWN -
UP +
2 RED FLASHES = CLOSE LIMIT STORED
LEARN
DOWN -
UP +
LEARN
DOWN -
UP +
2 GREEN FLASHES = SET UP LIMIT
PRESS UP (+) OR DOWN (-)
TO JOG THE DOOR TO THE
CORRECT POSITION
PRESS LEARN & UP
FOR 3 SECONDS
PRESS LEARN TO STORE LIMIT
LEARN
DOWN -
UP +
SETTING THE OPEN LIMIT
2 GREEN FLASHES = OPEN LIMIT STORED
LEARN
DOWN -
UP +
LEARN
DOWN -
UP +
6
6
X 6