Instructions / Assembly

5/16”-18 x 3/4" Bolt Grease Tube

5/16”-18 Keps Nut

1/4”-20 x 1/2" Flange Bolt

1/4”-20 Keps Nut

1D 1E 1G 1H

SLIDE THE TROLLEY

ONTO RAIL SECTION “A”

PULLEY

HOLES

PUT NUTS ON BOLTS

WITH JUST A FEW TURNS,

DO NOT TIGHTEN NUTS

AT THIS TIME.

2 3

Slide the Trolley onto the rail Sections “A”. Be sure

of proper trolley orientation.

Attach the Pulley Assembly to rail Section “A” with

(2) 5/16”-18 x 3/4” bolts and (2) 5/16”-18 Keps nuts

(supplied). DO NOT FULLY TIGHTEN AT THIS TIME.

SECTION “C”

SPROCKET

FLAT SIDE UP

SPROCKET

HOLDER

APPLY

GREASE

APPLY GREASE

SECTION “C”

Install trolley stop using 1/4”-20 x 1/2” Flange

bolt and 1/4”-20 keps nut (supplied).

Apply grease to inside surfaces of sprocket holder

as shown and place the Sprocket into the sprocket

holder with  at side up, then place Sprocket Holder

onto rail Section “C”, as shown.

HARDWARE

RAIL ASSEMBLY – continued

Completed rail assembly.