Installation Guide

Pole Mounting

2. Feed the wire through the mounting pole.

1. Remove the Photo Beam cover (as shown in step 1 above).

3. Using the Mounting Plate and Bracket secure the Photo

Beam to the mounting pole.

Back to Back Installation

(Refer to the gure above)

1. Remove Photo Beam

cover by loosening the

cover holding screw, but

DO NOT REMOVE THE

SCREW ALL THE WAY.

3. Remove the rubber

knockout and use the

screw holes to mount

the unit.

2. Pull the wire through the

wiring hole at the top of the

unit, from back to front.

4. Mount the Photo Beam on

the wall while running the wire

into the wiring location in the

wall.

Wall Mounting

GOOD LEVEL ALARM

RECEIVER

SCREW HOLE

Mounting

Bracket

Feed Wire

Through Pole

Base Plate