Datasheet

MikroElektronika
Figure 1: SHT1X additional board
How to connect the board?
The SHT1X additional board can be easily connected to a development system via 2x5 connectors. The board
communicates with the microcontroller supplied on the development system via two serial communication lines: SDA
- serial data transfer and SCL - serial clock. In order to establish connection between them, it is necessary to set the
appropriate switch on DIP switch SW1 to the ON position. Which of these switches will be set ON depends on the
development system in use, table 1.
SHT1X
The SHT1X additional board is used to measure temperature and relative humidity.
Key features:
- Serial communication;
- Measuring humidity (0 to 100%);
- Measuring temperature (-40 to +125C
o
)
- Low power consumption; and
- 2.4 to 5.5V power supply voltage.
SDA SCL
PIC 3 (P4) 7 (P3)
dsPIC 1 (P3) 5 (P2)
PIC24 1 (P3) 5 (P2)
PIC32 2 (P3) 6 (P2)
AVR 4 (P1) 8 (P0)
ARM 2 (P3) 6 (P2)
Position of switches on DIP switch SW1 for appropriate dev.system
Table 1