Quick Guide
Table Of Contents
Cloud Core Router 1016-12S-1S+
First use
The device comes preinstalled with RouterOS and is ready to use. The SFP port 1 has a default IP address for
connecting: 192.168.88.1. The username is admin and there is no password. Please connect with your web
browser to this IP address and choose Webfig to configure it. The device doesn’t have any other configuration
applied by default, please connect to it, and set up WAN IP addresses, user password, firewall etc.
See this page for connection and configuration guides: http://mt.lv/help
Powering
The device accepts powering from two redundant power supplies, each accepts 100-240V DC power. You can use
either, or both at the same time. Up to 44W power consumption.
Extension Slots and Ports
Twelve SFP cages
One SFP+ cage
microUSB type AB
RS232 serial port
Etherboot / Netinstall is available on port 12. One RJ45 SFP to Ethernet module is included for management
connectivity.
Buttons and Jumpers
The RouterBOOT reset button has the following functions. Press the button and apply the power, then:
Release the button when green LED starts flashing, to reset RouterOS configuration to defaults.
Release the button when the LED turns solid green to clear all configuration and defaults.
Release the button after LED is no longer lit (~20 seconds) to cause device to look for Netinstall servers
(required for reinstalling RouterOS over network).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Operating System Support
The device supports RouterOS software with the version number at or above what is indicated in the RouterOS
menu /system resource. Other operating systems have not been tested.
Safety Notice
Electric shock hazard. This equipment is to be serviced by trained personnel only.
See mikrok.com for more informaon. Document #42786 Modied on 16/08/18