Specifications

See mikrotik.com/products for the latest version of this document. Page 5, Document #51982 Modified on: 10.SEP.2019
OEM statement. This module is intended for OEM installations only.
As such the OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove
install or modify the module. This module is limited to installations in mobile or fixed applications. OEM integrators
may utilize antennas of like an equal or lesser gain as appearing in the list in this document (reference 47 CFR,
paragraph 15.204(c)(4) for further information on this topic. The MikroTik OEM RF Module complies with Part 15 of
the FCC rules and regulations.
The Grantee will provide guidance to the Host Manufacturer in ensuring complianc e with the Part 15 Subpart B
requirements.
OEM Modules have been certified by the FCC for use with other products without any further certification (as per
FCC section 2.1091). Separate approval is required for other operating configurations including portable
configurations with respect to 47CFR paragraph 2.1093 and different antenna configurations. The OEM is required
to comply with all 47CFR labeling instructions and requirements for the finished products.
Changes or modifications not expressly approved by MikroTik could void the OEM authority to install or operate the
equipment. OEMs must test their final product to comply with unintentional radiators (FCC section 15.107 and
15.109) before declaring compliance of their final product to Part 15 of the FCC Rules.
WARNING: the OEM must ensure that the FCC labeling requirements are met. This includes a clearly visible label
on the outside of the OEM enclosure specifying the appropriate MikroTik OEM RF Module FCC identifier for this
product as well as any other required FCC notices as presented below.
This enclosed device complies with 47CFR paragraph 15 C of the FCC rules and regulations. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Labeling and text information should be of a size of type large enough to be readily legible, consistent with the
dimensions of the equipment and the label.
WARNING: This device has been tested with a U.FL connector and antennas types as listed below. When
integrated into the OEM products, these fixed antennas require professional installation. Preventing end users from
replacing them with non-compliant antennas.
824-960 MHz approved antennas :
6.5 dBi Omni Directional TOF-0809-7V-S1
Antennas of same type and lower gain than those listed above may be used in compliance with certification.
Host product manufacturers that they need to provide a physical or e-label stating “Contains FCC ID” with their
finished product.
The ISED certification label of a module shall be clearly visible at all times when installed in the host product; otherwise,
the host product must be labelled to display the ISED certification number for the module, preceded by the word
"contains" or similar wording expressing the same meaning, as follows:
Contains IC: 7442A-LR9