Assembly instructions

5. Install Pole Fasteners
Determine the pole diameter which MikroTik Antenna will be attached to.
• If the pole diameter is less than 60mm( 2.375”) use the hole pattern from
Fig. 5.1 to install the M10x130 Bolts [I];
• If the pole diameter is 60 - 100mm (max) use the hole pattern from Fig. 5.2.
Install M10x130 Bolt [I] x 4 pcs using:
[Q] M10 Square Washer x 4 pcs;
[R] M10 Jam Nut x 4 pcs.
Important:
•M10 Jam Nut [R] tightening torque must be approximately 4 Nm.
6. Attach Antenna to Pole
MikroTik Antenna is design to t the pole diameter up to 100mm( 3.9”).
Attach MikroTik Antenna to pole as shown in Fig. 6 using:
[E] Pole Clamp x 2 pcs;
[S] M10 Fender Washer x 4 pcs;
[T] M10 Spring Lock Washer x 4 pcs;
[U] M10 Nut x 4 pcs.
Important:
• M10 Nuts [U] tightening torque must be approximately 25 Nm.
7. Adjust Azimuth
Loosen the fasteners on Mounting Bracket [D], which lock the azimuth angle.
Turn the horizontal Alignment Mechanism to precisely adjust the azimuth
- see Fig. 7.
After setting the azimuth, tighten rmly the corresponding fasteners on the
Mounting Bracket [D].
Important:
• Use 10mm Wrench to turn Adjustment Mechanism;
• M6 Nuts [Q] tightening torque must be approximately 7 Nm.
IF POLE Ø < 60mm
IF POLE Ø > 60mm
R Q I
FIG. 5.3FIG. 5.2
FIG. 5.1
FIG. 6
ØMAX = 100mm
E
S
T
U
FIG. 7
TURN TO ADJUST AZIMUTH
LEFT
RIGHT