Quick Guide

5. Attach MikroTik Radio to Back Plate
Attach a MikroTik RB900 series outdoor device to Case Holder [H] using:
[-] M3x8 Bolt x 4 pcs (Comes with MikroTik Radio) - see Fig. 5.1.
Attach Case Holder [H] to Back Plate [D] by tting Case Holder’s hinges
into the Back Plate’s ange - see Fig. 5.2. Secure Case Holder using:
[O] M4 Wing Nut x 1 pc.
Important:
• M3x8 Bolt [-] tightening torque must be approximately 1.5 Nm.
6. Install RF Cables
Remove the cover from MikroTik Radio and install the RF Cables [I].
Connect vertical polarization (arrow V) to CH0, horizontal polarization
(arrow H) to CH1 - see Fig. 6.
Insulate the RF Cable [I] ends which are connected to Antenna Feed [B]
by using: [J] Self-Bonding Tape Slice x 2pcs.
• Remove the plastic liner from both sides;
• Stretch the tape to 2/3 of its width;
• Apply half-lapped layers clockwise.
The RF Cable [I] ends which are connected to MikroTik Radio are insulated
by the cover.
Fit back the MikroTik Radio cover.
Important:
• RF Cables [I] connector tightening torque must be approximately 0.5 Nm.
7. Install Pole Fasteners
Determine the pole diameter which MikroTik Antenna will be attached to.
• If the pole diameter is less than 60mm( 2.375”) use the hole pattern from
Fig. 7.1 to install the M10x130 Bolts [K];
• If the pole diameter is 60 - 100mm (max) use the hole pattern from Fig. 7.2.
Install M10x130 Bolt [K] x 4 pcs using:
[U] M10 Square Washer x 4 pcs;
[V] M10 Jam Nut x 4 pcs.
Important:
• M10 Jam Nut [V] tightening torque must be approximately 4 Nm.
8. Attach Antenna to Pole
MikroTik Antenna is design to t the pole diameter up to 100mm( 3.9”).
Attach MikroTik Antenna to pole as shown in Fig. 8 using:
[G] Pole Clamp x 2 pcs;
[W] M10 Fender Washer x 4 pcs;
[X] M10 Spring Lock Washer x 4 pcs;
[Y] M10 Nut x 4 pcs.
Important:
• M10 Nuts [Y] tightening torque must be approximately 25 Nm.
M3x8
H
O
FIG. 5.1
FIG. 5.2
D
H
V
J
I
FIG. 6
B
IF POLE Ø < 60mm
IF POLE Ø > 60mm
V U K
FIG. 7.3FIG. 7.2
FIG. 7.1
ØMAX = 100mm
G
W
X
Y
FIG. 8