Quick Guide

Buttons and jumpers
The reset button has the following functions:
 Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS
configuration.
 Or Keep holding the button for 5 more seconds until until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers connected to it’s first Ethernet port.
The bypass switch allows to bind ports 11 and 12 together in bypass mode, which means that if the device loses
power, the ports will be connected together, allowing data pass from one port to the other, as if the device would
not be there.
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Operating system support
The device supports RouterOS software with the version number at or above what is indicated in the RouterOS
menu /system resource. Other operating systems have not been tested.
See mikrotik.com for more information. Document #48681, modified on 04/08/19