Quick Guide

RouterBOARD 3011UiAS-RM
First use
• Connect your Internet cable to port 1, and local network PCs to ports 2-10.
• Choose your powering solution, please see Powering section for possibilities.
• Set your computer IP configuration to automatic (DHCP).
• Default IP address from the local network is 192.168.88.1, open this address in your web browser to start
the configuration. The username is admin and there is no password.
• We recommend clicking the “Check for updates” button and updating your RouterOS software to the latest
version to ensure the best performance and stability.
• Set up your password in the screen that loads.
Powering
The device accepts powering from either the power jack or from the LAN1 Ethernet port:
• Direct-input power jack (5.5 mm outside and 2 mm inside diameter, female, pin positive plug) accept s 14-
30 V DC ⎓ (overvoltage protection starts at 30 V).
• Eth1 port accepts 14-30 V DC input (at the board; higher voltage needed to compensate for power ⎓ loss
on long cables) from non-standard (passive) Power over Ethernet injectors. The board does not support
IEEE802.3af compliant 48 V power injectors.
The power consumption under maximum load can reach 30 W.
Connecting to a POE Adapter:
1. Connect the Ethernet cable from the device to the POE port of the POE adapter.
2. Connect an Ethernet cable from your LAN to the LAN port of the POE adapter, please mind arrows for data
and power flow.
3. Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Extension slots and ports
• Ten 10/100/1000 (Gigabit) Ethernet ports (Auto MDI/X).
• USB 3.0 type A.
• LCD panel.
• SFP port for SFP module.
• The Ether10 port supports PoE output, with auto-detection feature. This means you can connect Laptops
and other non-PoE devices without damaging them. The PoE on Ether10 outputs approximately 2 V below
input voltage and supports up to 0.7 A (So provided 24 V PSU will provide 22V/0.7 A output to the Ether10
PoE port).
See mikrotik.com/products for the latest version of this document. Document #50309 Modified on: 27.JUN.2019