User Manual

1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
hEX S
hEX S
hEX S is a six-port wired Gigabit router with SFP port and PoE output.
First use
Connect your Internet cable to one of the two ports labeled "Internet", depending on whether you will use an SFP module or Ethernet.
Choose your powering solution, please see the section for possibilities.Powering
Connect your direct input power jack if not using POE, to start up the device.
Connect your local network computers to ports 2-5 set your computer IP configuration to automatic (DHCP).
The IP address from the local network is 192.168.88.1, use it in your browser to access the device.
We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best
performance and stability.
Set up your password on the screen that loads.
Mounting
This device is designed for use indoors by placing it on the flat surface or mounting on the wall, mounting points are located on the bottom side of the
device, screws are not included in the package. Screws with size 4x25 mm fit nicely, depending on your wall structure you can use dowels 6x30 mm and 6
mm drill bit if needed.
When mounting on the wall, please ensure that cable feed is pointing downwards. We recommend using Cat6 shielded cable for our devices. The IP rating
scale for this device is IPX0.
Configuration
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: .https://mt.lv/help
In case IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC address of the device from the LAN side https://mt.lv/winbox
(all access is blocked from the internet port by default). For recovery purposes, it is possible to boot the device from the network, see section Buttons
Powering
The device accepts power from the power jack or from the first Ethernet port:
Direct input power jack (5.5mm outside and 2mm inside, female, pin positive) accepts DC 12-57 V.
The first Ethernet port accepts passive or 802.3af/at Power over Ethernet in the range of DC 12-57 V.
The power consumption of this device under maximum load without attachments is up to 6 W.
When using 802.3af/at to power this device, we recommend not using grounding for best compatibility.
Connecting to a POE Adapter:
Connect the Ethernet cable from the device to the POE port of the POE adapter.
Connect an Ethernet cable from your LAN to the LAN port of the POE adapter, please mind arrows for data and power flow.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Extension Slots and Ports