User Manual

Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers (total 15
seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Accessories
The package includes the following accessories that come with the device:
EU/US Switching Power Supply 24 V DC , 0.8 A, 19.2 W.
Hose clamp 40/60 w2 A2 9 mm.
2pcs - Plastic tie strap fastener (300 mm(L) 7,6 mm(W)).
Gigabit POE injector cable with shielded connector (RBGPOE).
K-27 din-rail bracket mounting set.
Antenna usage
To connect to the external antenna please use, the "Flex-guide" - can be obtained separately. A super low loss 50cm long RPSMA cable for superior
connection quality, suited for indoor and outdoor use, this cable provides superior matching and loss values. https://mikrotik.com/product/ACRPSMA
SMA connectors located under the upper cover (see " ") to access them.Removing upper cover
Wireless interface configuration information on the web: https://wiki.mikrotik.com/wiki/Manual:Interface/Wireless
Specifications
For more information about this product, specifications, pictures, downloads, and test results please visit our web page: https://mikrotik.com/product
/RB911G-5HPacD-NB
https://i.mt.lv/cdn/rb_files/NetBox-1566373542.pdf
- RB911G-5HPacD-NB-US (USA) is factory locked for 5170-5250MHz and 5725-5835MHz frequencies. This lock can not be removed.
- RB911G-5HPacD-NB (International) supports the 5150MHz-5875MHz range (Specific frequency range can be limited by country regulations).
Operating system support
The device supports RouterOS software version 6.44.5 The specific factory-installed version number is indicated in the RouterOS menu /system resource.
Other operating systems have not been tested.
Compliance Information
Safety Information:
Please connect and disconnect the antenna, when the device is turned off!