User Manual

RB912UAG-series
This manual covers RouterBOARD 912UAG series models:
RB912UAG-5HPnD
RB912UAG-2HPnD
Mounting
912UAG series router for professional use. Each of the devices comes in ESD protective packaging. When handling electrical equipment please observe
the following safety precautions:
use a wrist grounding strap when unpacking and working with electrical components to avoid electrical discharge (ESD) damage,
after unpacking please place the router on the anti-static mat,
when mounting unit make sure there are no objects that can damage or touch the PCB plate,
note that ETH, USB port and DC jack are extending over the perimeter of the PCB plate.
The device can be mounted in your desired location using the factory provided four holes in a PCB plate, located on each side of the device.
Warning! This equipment should be installed and operated with a minimum distance of 380 cm between the device and your body. Operation of this
equipment in the residential environment could cause radio interference.
Connecting
1. Choose your powering solution, please see section for possibilities.Powering
2. If needed, connect accessories to the miniPCIe slot, antenna cables to the miniPCIe card and insert SIM
card.
3. Connect your ethernet cable to the gigabit ethernet port.
4. Connect your direct input power jack if not using POE, to start up the device.
5. The device will boot up and after short beep Wireless network will be available for connecting.
6. Open network connections on your pc, mobile phone or other device and search for MikroTik wireless
network and connect to it.
7. Once connected to the wireless network, open in your web browser to starthttps://192.168.88.1
configuration, since there is no password by default, you will be logged in automatically.
8. We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest
version to ensure the best performance and stability.
9. Choose your country, to apply country regulation settings and set up your password in the screen that
loads.
Powering
The device accepts power with the following modes:
Passive 10-30 V PoE to the ethernet port. The higher the voltage needed to compensate for power loss on long cables. At least 18 V is suggested.
Direct input to the power jack 10-30 V.
Maximum power consumption 14 W.
Configuration
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: . In case IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC address https://mt.lv/help https://mt.lv/winbox
of the device from the LAN side (all access is blocked from the Internet port by default).
For recovery purposes, it is possible to boot the device from the network, see a section .Reset button
Extension slots and ports