User Manual

Accessories
The package includes the following accessories that come with the device:
Switching Power Supply DC 24 V;
Hose Clamp, 35-70 mm;
Fastening set K-41;
Gigabit POE injector cable with shielded connector;
Mounting bracket.
Please visit wiki pages for the MikroTik SFP module compatibility table: https://wiki.mikrotik.com/wiki/MikroTik_SFP_module_compatibility_table
Operating system support
The device supports RouterOS software version 6.46. The specific factory-installed version number is indicated in the RouterOS menu /system resource.
Other operating systems have not been tested.
Federal Communication Commission Interference Statement
FCC ID:TV7D2352AC
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a commercial installation
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to ensure compliance.
Antenna Installation WARNING: It is the installer's responsibility to ensure that when using the authorized antennas in the USA (or where FCC rules apply);
only those antennas certified with the product are to be used. The installer should configure the output power level of antennas, according to country
regulations and per antenna type. Professional installation is required for equipment with connectors to ensure compliance with health and safety issues.
LIST OF APPROVED 2.4 GHz ANTENNAS:
3.6 dBi Dipole Antenna (Model: HGO-antenna-OUT)
5 dBi Dipole Antenna HP (Model: DA-2450-05RP-SMA-01 (ACOMNIRPSMA))
LIST OF APPROVED 5 GHz ANTENNAS:
6.68 dBi Dipole Antenna (Model: HGO-antenna-OUT)
19 dBi Sector Antenna (Model: MTAS-5G-19D120)
30 dBi Parabolic Dish Antenna (Model: MTAS-5G-30D3)
The same type of antenna and lower antenna gain than those listed above may also be used in accordance with the certification.
Innovation, Science and Economic Development Canada
IC:7442A-D2352AC