User Manual

1.
2.
3.
1.
Supports -GPS, GLONASS, BeiDou, Galileo).
Make sure that the GPS package is installed on your device. Check by following command /system package print. If not installed please download extra
packages at our download page accordingly to your RouterOS version and install the GPS package by dragging it to the Files menu. Enable GPS and start
working:
Enabling - /system gps set enable=yes;
Setting antenna to external - /system gps set gps-antenna-select=external;
Checking configuration - /system gps print.
https://wiki.mikrotik.com/wiki/Manual:System/GPS
LR usage
For interface configuration please visit https://wiki.mikrotik.com/wiki/Manual:Interface/Lora
We recommend using our antenna kit, https://mikrotik.com/product/lora_antenna_kit
USB usage
When using an LR card the USB port power will be switched off by the CPU. It cannot be used together with an LR card.
Automotive connector usage
Powering
Direct-input power jack (5.5 mm outside and 2 mm inside, female, pin positive plug) accepts 12-30 V DC with provided 24 V, 1.2 A adapter.
Ethernet port accepts passive Power over Ethernet 12-30 V DC (compensate for the loss on cable, so more than 12 V recommended).
The automotive connector can be used to power the device from regular 12/24 V connections in automobiles and buses. The plug has four pins:
bottom left (black) is the ground, bottom right is power in (red). The upper two (AUX) are reserved for future use.
The power consumption under maximum load can reach 12 W without attachments. Please attach ground (earth) wire to the screw under the door.
Connecting to a POE Adapter: (Not included)
Connect the Ethernet cable from the device to the POE out port of the POE adapter.
Connect an Ethernet cable from your LAN to the POE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Front status LED behavior