User Manual

1.
2.
3.
4.
5.
6.
7.
RBM11G
First use
Insert the miniPCIe card (not included), please see paragraph .MiniPCIe slot
(Optional) Install the device in a case.
Connect antenna cables to the miniPCIe card and an Ethernet cable to the gigabit Ethernet port.
Plug-in power cable to turn on the device.
We recommend connecting to the device using Winbox with a default IP address of 192.168.88.1 with the username admin and no password.
Mounting
M11G router for professional use. Each of the devices comes in ESD protective packaging. When handling electrical equipment please observe the
following safety precautions:
Use a wrist grounding strap when unpacking and working with electrical components to avoid electrical discharge (ESD) damage.
After unpacking please place the router on the anti-static mat.
When mounting unit make sure there are no objects that can damage or touch the PCB plate.
Note that ETH and DC jack is extending over the perimeter of the PCB plate.
The device can be mounted in your desired location using the factory provided four holes in a PCB plate, located on each side of the device.
MiniPCIe slot
Installing a miniPCIe module should be done by a qualified person, please follow safety precautions when handling electrical equipment:
Place the device on the anti-static mat.
Locate the miniPCIe slot and remove two factory attached screws.
Attach provided a thick thermal pad to the card, and install the card into miniPCIe slot so that the thermal pad is between PCB and card.
The secure card in place using previously removed two screws.
Attach the grey uFL connector to the MAIN antenna connector of the modem, attach the black cable to the secondary (or AUX) connector.
Attach a thinner thermal pad to the top of the card.
Mount unit in your desired location.
After you mounted the device, slide in the SIM card from your mobile operator into the SIM slot, with the chip facing down. The slot accepts miniSIM (2FF).
Powering
The device accepts power with the following modes:
Passive 10-30 V PoE to Ethernet port. The Higher voltage needed to compensate for power loss on long cables. At least 18 V is suggested.
Direct input to the power jack 10-30 V.
Maximum power consumption 11 W.
Booting process
RouterOS is the operating system of all RouterBOARD routers. Please see documentation here: https://mt.lv/help
This device is not preconfigured other than an IP address on the Ethernet port. Another configuration has to be applied according to the documentation
manual linked above.
The Initial connection has to be done via the Ethernet cable, using the MikroTik Winbox utility. Winbox should be used to connect to the default IP address
of 192.168.88.1 with the username admin and no password.
In case you wish to boot the device from the network, for example, to use MikroTik Netinstall, hold the reset button of the device when starting it until the
LED light turns off, and the device will start to look for Netinstall servers.
In case the IP connection is not available, the Winbox utility can also be used to connect to the MAC address of the device. More information in the
documentation.