User's Manual

See www.routerboard.com for more information. Contact [e-mail] for support questions. 15-Nov-2011
Federal Communication Commission Interference Statement (FCC ID:
TV7GROOVE-2HN)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. This device and its antenna must not be co-located or op-
eration in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
32 cm minimum distance has to be maintained between the antenna and the occupational user and 100 cm to general public.
Under such configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be satis-
fied.
MODIFICATIONS
The FCC requires the user to be notified that any changes or modifications to this device that are not expressly approved by the
manufacturer may void the user’s authority to operate the equipment. The correction of interference caused by unauthorized
modification, substitution or attachment will be the responsibility of the user. The manufacturer and its authorized resellers or
distributors are not liable for any damage or violation of government regulations that may arise from failing to comply with
these guidelines.
PROFFESIONAL INSTALLATION ATTESTATION
MIKROTIKLS SIA addresses the following items to ensure that the above referenced equipment is professionally installed:
1. The TV7GROOVE-2HN will only be sold by MIKROTIKLS SIA or one of its authorized dealers. MIKROTIKLS
SIA and its authorized dealers will be under strict marketing control and will only market and sell the TV7GROOVE-
2HN to professionals.
2. Professional installation is required for the TV7GROOVE-2HN and will be performed only by someone knowledgea-
ble of its use. MIKROTIKLS SIA will ensure that the TV7GROOVE-2HN is only marketed and sold to professionals.
3. The TV7GROOVE-2HN is not sold to the general public and is sold only for industrial or commercial use by profes-
sional installers.
LIST OF APPROVED ANTENNAS
o 24 dBi Dish DC 24-HD-PFIP
o 20 dBi Panel WLP-2450-20
o 17 dBi Sector SA 24-90-17-WB
o 15 dBi Omni Directional (pole) WL0-2450-15
o 13 dBi Omni Directional (hor. Polarization) HP, 0DH 24-13
Antennas of same type and lower gain than those listed above may be used in compliance with certification.