User's Manual

Seewww.routerboard.com formore information. Contact[e-mail] forsupportquestions. 21/08/13
Next,put the twoUbolts (C) aroundthe mast or pole, andguide
them through the holes on the swivel adjuster (D).Then, tighten
the Ubolts, eachwithone regular washer, one spring washer, and
one nut,asshownintheimagetothe right. All nuts needtobe
tightened using a size 10 (3/8 in)wrench.
Now take the mounting bracket (E), and put it on to the
back of the antenna. Use one rubber ring, one washer, and
one nut foreach of the builtin bolts (in that order).
Finally, attach theswivel adjuster to themounting
bracket. Use the long bolt intheposition (F). Put
one regular washer, andone spring washer ontothe
shorter screws, then put them in positions(G). Do
not tightentoomuch, as youneedtoadjust the
antennanow.
Once antenna level and angle are adjusted
according to thewireless signal in software, tighten
all nuts.Note the degrees of angle forfuture
reference.
C
D
F
E
G
G