User's Manual

Federal Communication Commission Interference Statement

(FCC ID: TV7QRTG2SHPND)

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in

a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate this

equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

This device and its antenna must not be co-located or operation in conjunction with

any other antenna or transmitter.

IMPORTANT: Exposure to Radio Frequency Radiation.

28 cm minimum distance has to be maintained between the antenna and user.

Under such configuration, the FCC radiation exposure limits set forth for an

population/uncontrolled environment can be satisfied.

See www.routerboard.com for more information. Contact support@mikrotik.com for support questions. 12/02/14